Red dot mounts for SAR models

This collection contains a red dot mount for the SAR9. It is an Outer Impact type C, machined from aluminium in the USA. It takes red dots with the Trijicon RMR, C-More RTS or Docter footprint. The mount replaces the rear sight, with no slide milling or permanent modifications.

Installation

Drift the rear sight out of the dovetail with a sight pusher or a punch. Push the mount into the same dovetail and fix it. Then screw the red dot onto the mount. No slide milling or permanent modifications are needed. See Installation tools.

See Red dot mounts for SAR9. For other brands, see Red dot mounts.

Frequently asked questions

Can I put a red dot on my SAR9 without an optic cut?

Yes. The mount goes into the rear sight dovetail in place of the rear sight. No milling and no permanent changes, so you can put the rear sight back at any time.

Can I install the mount at home?

Yes, if you have a sight pusher or a punch.

1. Drift the rear sight out of the dovetail.
2. Push the mount into the dovetail and tighten it.
3. Screw the red dot onto the mount with a drop of threadlocker on each screw.

You find the tools in Installation tools.

Which red dots will fit?

It depends on the mount you choose. Every mount takes one footprint or a group of footprints. For SAR9 we have mounts for the Trijicon RMR, Docter and C-More RTS footprints.

Find the footprint of your red dot in its specifications and take the mount that names it.