This collection contains footprint adapters. A footprint adapter sits between a plate, mount or slide cut and your red dot. It converts one footprint to another. Use it if your plate or slide cut does not match the footprint of your red dot.
Available conversions
- From Trijicon RMR to Shield RMSc (Shield Sights). It does not fit RMR slide cuts with upstanding screw posts.
- From Trijicon RMR to Shield RMSc and Holosun K-series (Olight). Screws and an installation tool are included.
- From Trijicon RMR to Holosun K-series (Holosun).
- From Trijicon RMR to Holosun 509T (Holosun).
- From Trijicon RMR to Aimpoint Acro (Vector Optics).
- From Shield RMSc to Holosun K-series (Holosun). You may need to shorten the original screws slightly.
- From Toni System type A to Aimpoint Acro (Toni System). It fits only Toni System plates and mounts of type A. Recommended torque is 1.5 Nm.
What to consider
An adapter adds height between the slide and the red dot. The red dot sits higher, and your iron sights may no longer co-witness through the window. Most adapters are made of aluminium, and most come with screws.
Related collections
Before you buy an adapter, check if a plate for your footprint exists. See Optic ready plates by footprint. For mounts, see Red dot mounts.
Frequently asked questions
When do I need a footprint adapter?
When the footprint of your red dot does not match your plate, mount or optic cut, and there is no plate for your red dot.
Do I need longer screws?
Most adapters come with screws. For the Shield RMSc to Holosun K-series adapter, you may need to shorten the original screws slightly.
Does the red dot sit higher with an adapter?
Yes. The adapter adds its own height, so co-witness sights may no longer line up with the dot.
Sold out
New arrival
